3D Modeling

3D modeling with Rhinoceros 5

CLICK HERE TO REGISTER

 

Rhinoceros Basic Training  (9 hours)

modeling tools for designers

 

 

Friday NOV 6, from 17:00 to 20:00 (3 hours)

Part 1: Introduction to NURBS

 

Saturday NOV 7, from 10:00 to 13:00 (3 hours)

Part 2: Creating 2D geometry

 

Saturday NOV 7, from 14:00 to 17:00 (3 hours)

Part 3: 3D modeling & extras

 

 

DURATION: 9 hours (3 sessions of 3 hours)

COST: Early Bird ticket = 300 € / Standard ticket = 330 €

limited seats available (8 participants)

 

ROOM: ALCÁNTARA (3rd floor of Technoport @Belval)

 

IMPORTANT:

Every participant should bring his or her own laptop with the software installed.

Don’t have a license? click here to download the evaluation version.

This fully functional (except the clipboard) Rhino 5 version will save 25 times. After that it is still functional except it will not save and plug-ins will no longer run.

For further information about it, please contact us via fablablux@technoport.lu

Technoport Fab Lab is an Authorized Rhino Training Center. 

Authorized Rhino3D Trainer: Rodolfo Baïz